True duals
Thread Starter
TECH Enthusiast
iTrader: (16)
Joined: Jun 2005
Posts: 732
Likes: 1
From: San Luis Obispo, CA
True duals I decided that I definitely want to go with true duals for my 02 A4 Z28 
. I just can not decide on a setup, I have been looking at a Magnaflow setup that seems pretty good and affordable? Anyone have any suggestions on what to run and where I can get it?
. I just can not decide on a setup, I have been looking at a Magnaflow setup that seems pretty good and affordable? Anyone have any suggestions on what to run and where I can get it? i run the bassani tru-duals on both cars. bolts directly to the stock cats on 00-02 cars.
http://www.vincihighperformance.com/...s1exhaust.html you can get them from here. sound bytes on this page are from my cars.
this system made 15 rwhp more over the borla i had on the wife's car.
http://www.vincihighperformance.com/...s1exhaust.html you can get them from here. sound bytes on this page are from my cars.
this system made 15 rwhp more over the borla i had on the wife's car.
11 Second Club
iTrader: (27)
Joined: May 2005
Posts: 6,799
Likes: 5
From: Your girl's back door giving her the long stroke while you're at work
I have limited ground clearance with my TSP TDs, only about 4 in. and the car is not lowered. I also had a problem with the pipe under the driver floorboard hitting. But that was nothing a sledgehammer didn't fix. But other than that I love them.
I'm doing my own with a friend using 3' pipe from slp lt's,no cats and using dynomax bullets over the axle.Will also be using the crossover pipe.The whole thing will cost about 400-450.
Trending Topics
Thread Starter
TECH Enthusiast
iTrader: (16)
Joined: Jun 2005
Posts: 732
Likes: 1
From: San Luis Obispo, CA
I know those flowmasters sound good, but they are not loved on this board for reasons of poor flow. Those 1 chambers are flowmasters correct? Do they flow any better than normal Flowmasters?
LS1 Tech Stories
The Best V8 Stories One Small Block at Time
6 Gifts Neither Your Dad Nor Grad Will Shove Into the 'Trinket Drawer'
Brett Foote
Topdon ONE vs. Artidiag 800 BT2: Which is the Diagnostic Tablet For You?
Pouria Savadkouei
Gas Monkey Built a 6-Wheel Ferrari Testarossa With a Corvette LT4 Engine
Verdad Gallardo
7 Most Reliable High-Performance Engines GM Has Ever Built
Verdad Gallardo
Amazing '71 Camaro Restomod Is Modern Muscle Car Under the Skin
Verdad Gallardo
6 Common C5 Corvette Failures and What's Involved In Repairing Them
Pouria Savadkouei
Retro Modern Bandit Pontiac Trans AM Comes With Burt Reynolds' Autograph
Verdad Gallardo
Top 10 Greatest Cadillac V Series Performance Models Ever, Ranked
Pouria Savadkouei
Top 10 Most Powerful Chevy Trucks Ever Made!
Originally Posted by kilr12
I'm doing my own with a friend using 3' pipe from slp lt's,no cats and using dynomax bullets over the axle.Will also be using the crossover pipe.The whole thing will cost about 400-450.
Originally Posted by 01TAFlyer
400-450 for over the axle? That is cheap, I wish I had accesst to the tools to do that myself, and the abillity
