BMR lid
Thread Starter
On The Tree
iTrader: (1)
Joined: Aug 2005
Posts: 109
Likes: 0
From: College Station, TX
BMR lid I was looking at BMR's website and the picture of their Xtreme duty shock tower brace under '93-'02 F-bodies shows a HUGE airlid. I asked them and they said that was one of their previous offerings but they no longer have it. Does anyone know anything about them or where to find one?
http://www.bmrfabrication.com/Xtreme/XSTB001.jpg
http://www.bmrfabrication.com/Xtreme/XSTB001.jpg
12 Second Club
Joined: Sep 2005
Posts: 4,273
Likes: 0
From: Bucks County, Pa.
Is that photoshopped or did that really exist? The whole shroud assembly is completely different. Unless they did some funky stuff underneath that thing I doubt it made any more power than the common setups.
That was a replacement intake set up that turned out to be too expensive and not cery durable. A couple of our sponsors use to sell them.
I believe it was called a "Stealth Intake"
I believe it was called a "Stealth Intake"
Yup, John is correct, it is a Stealth Lid made by PPO. It uses a Corvette air filter and specail, enlarged LS1 lid setup. An ex-coworker of mine purchase one for his 2002 SS. It was kind of a pain to install IIRC from what he told me. The improvements weren't much better than the OE styled LS1 lids.
John, I hope this is OK to post? It is a link to PPO and the stealth lid.
http://www.performancepartsoutlet.co...lth_airbox.htm
If not, you can delete it.
John, I hope this is OK to post? It is a link to PPO and the stealth lid.
http://www.performancepartsoutlet.co...lth_airbox.htm
If not, you can delete it.
