dent removal in header question?
Thread Starter
On The Tree
Joined: Jan 2005
Posts: 114
Likes: 0
From: Euless, Tx
dent removal in header question? Is it possible to remove dents out of stainless steel long tubes? The dent is about a quarter inch in diameter and a 1/4 of an inch deep. I would hate to have to purchase one new header.
Last edited by kendo347; Dec 11, 2005 at 08:13 PM.
Teching In
Joined: Dec 2005
Posts: 9
Likes: 0
From: shelby twp. MI
if you can access the dent from the inside of the tube you can carefully heat the tube around the dent and take something to carefully pry it out. method 2 would be to cut out the piece and weld a new piece in.
