MetallicaMatt

iTrader: (19)

i'm going to put on a cutout on my exhaust, and instead of welding them all the way around, could i tack it on a few spots (so it'll be easier to take off) and put header wrap around the ends?

would that seal it up?

I've never used the stuff before, looking for some ideas

thanks guys

LS69TA

iTrader: (30)

No, the wrap doesn't seal that good. It's made of fibers woven together.

slow trap

iTrader: (22)

why will you want to take it back off ?

Starz T/A 17

iTrader: (6)

The header wrap wont keep it from heating it is meant to absorb heat so that it keeps underhood temps down. You could always clamp it down I used clamps and never had a problem with it

MetallicaMatt

iTrader: (19)

what clamps?

redbullapril23

you could always weld the 3 bolt flange connectors on it....

Starz T/A 17

iTrader: (6)

I just cut the catback a little bit and put it between the catback and Y pipe and used "U" clamps from advanced auto to hold it. Sure its not the best but it worked

orangeapeel

iTrader: (18)

It is not worth it IMO. Coating would work better.

magius231

iTrader: (8)

just throw some band clamps on it. No crimping and you can take it off if you need later.

MetallicaMatt

iTrader: (19)

thanks guys!