This is my FAST90MM intake manifold. I have dismantled it, shaved the logos off, sprayed it, and ported the runners. Some of these pics blow, but you get the point, and some are excellent quality.

Shaved manifold (top piece only)


These pics were taken with no porting done - notice the ridge inside the runners? That had to go






Here are some of the runners after porting - an outside view...






Here is an inside view of an unported runner, again, notice the ridge. This thing kills airflow.


Here are some inside views of ported runners.






Here is the painted top piece - looks stealthy...

 

Daaaaaaamn!

 

looks pretty good.

 

nice!!!

 

nice - did you port match it or just remove those ridges?

 

Sleeper

 

looks really good!!!!

 

Looks good man. I painted mine as well. What type of paint did you use?

 

I did not attempt to do port matching. I don't have the know-how and I don't want to destroy my intake.

I used several coats of primer, and then painted it with engine block black enamel.

 

i just did the same, ported out the ridges and painted......

(in progress)





and painted to match the car..

 

You will have to portmatch also for better performance. He epoxied port floor for a better match. Read post #11 hear. https://ls1tech.com/forums/advanced-engineering-tech/457394-manifold-test-afr-225-a.html

 

looks good i saw some one who did that on there c5 it looked good. i like "stang killa 2" that looks pimp!

 

Pewter

 

that looks pimp too!

 

I want to paint mine but I dont think it would look good with the painted to match fuel rail covers right next to the intake. It would be to much pewter in one spot.

 

I am getting ready to paint mine next week. It will be gloss black with red fast and white wilson logo. Along with red valvecovers and coil brackets. I have red anodized fast rails. And a perdy billet TB with a billet N2O ring.