3.5" Collectors
Thread Starter
TECH Apprentice
Joined: Feb 2002
Posts: 358
Likes: 0
From: Alta Loma, CA
3.5" Collectors Who is running these? I have a set of Dynatech stepped headers and the only collectors in stock at the time were the 3.5" What do you guys think? I can get the 3" in a week or so, should I wait?
Thread Starter
TECH Apprentice
Joined: Feb 2002
Posts: 358
Likes: 0
From: Alta Loma, CA
Re: 3.5" Collectors I guess I will share the remainder of the exhaust plans. If I go with the 3.5" collectors I will run 3.5" cutouts, neck down to 3" and then use a Flowmaster dual 3" into 4" collector and then neck it down to mate with my Borla.
TECH Enthusiast
Joined: Nov 2001
Posts: 677
Likes: 0
From: Baton Rouge, La. and sometimes Houston Tx
Re: 3.5" Collectors I've got 3.5" collectors I"m planning to run. I'm going to add an extension on each side to give the 02's a little more space and hopefully build a little torque. Then dual 3.5" cutouts reduced to dual 3" and both pipes running through 3" Bassani Muffler and turning down at the axle. The 3.5" collectors aren't too big if you plan on doing a lot of mods <img border="0" title="" alt="[Wink]" src="gr_images/icons/wink.gif" />
TECH Enthusiast
Joined: Mar 2002
Posts: 505
Likes: 0
From: NJ
Re: 3.5" Collectors when i baught my stepped dynatech heads i also asked about the 3.5" collectors and they said that they arent needed until the 1000hp area. If you are going to run a 3.5" exhaust, it might be feasable, but you might loose exhaust velocity. I would call Madman or Jay billingsley
------------------------------------------->
------------------------------------------->
