Pulley install on A4?
Launching!
Joined: Nov 2001
Posts: 246
Likes: 0
From: Plano, TX
Re: Pulley install on A4? </font><blockquote><font size="1" face="Verdana, Helvetica, sans-serif">quote:</font><hr /><font size="2" face="Verdana, Helvetica, sans-serif">Originally posted by SPANKY LS1:
<strong>How do you keep the motor from turning while you are trying to break the bolts loose? TIA, Shawn</strong></font><hr /></blockquote><font size="2" face="Verdana, Helvetica, sans-serif">There are 3 ways:
1. The officially approved way - remove starter and buy a special part that has a few teeth and bolts up where the starter goes, preventing your motor from turning over.
2. Remove some of the access panels around your torque converter and stick a big screw driver through one of the holes in the flywheel.
3. As previously mentioned, Big-*** impact wrench with the air pressure cranked way up
<img border="0" alt="[Fluffy]" title="" src="graemlins/fluffy.gif" />
<small>[ July 08, 2002, 12:23 AM: Message edited by: Red2000SS ]</small>
<strong>How do you keep the motor from turning while you are trying to break the bolts loose? TIA, Shawn</strong></font><hr /></blockquote><font size="2" face="Verdana, Helvetica, sans-serif">There are 3 ways:
1. The officially approved way - remove starter and buy a special part that has a few teeth and bolts up where the starter goes, preventing your motor from turning over.
2. Remove some of the access panels around your torque converter and stick a big screw driver through one of the holes in the flywheel.
3. As previously mentioned, Big-*** impact wrench with the air pressure cranked way up
<img border="0" alt="[Fluffy]" title="" src="graemlins/fluffy.gif" />
<small>[ July 08, 2002, 12:23 AM: Message edited by: Red2000SS ]</small>
