k&n in a ws6=??problems??
Thread Starter
Teching In
Joined: May 2006
Posts: 7
Likes: 0
From: North Carolina
k&n in a ws6=??problems?? I need to know if anyone has had problems with a k&n filter in a ws6. My car is a everyday driver and it does see some rain. What I want to know is has anyone had any problems with the rain water getting to the filter and does it require the filter to be cleaned more often than normal. I am kind of expecting the rain to turn the dirt it traps to hard mud????
12 Second Club
Joined: Sep 2005
Posts: 354
Likes: 0
From: Springfield, Missouri
unless your driving threw a lake or water above your hood and your on the stock air box then you will not have a problem. if you don't beileve me then take a gander at how air comes into your engine.
Thread Starter
Teching In
Joined: May 2006
Posts: 7
Likes: 0
From: North Carolina
The reason that I ask is the paper filter that came out was sooooo bowed up it was not making a proper seal in the air box. So there has to be a good amount of moisture getting to the filter.
Thread Starter
Teching In
Joined: May 2006
Posts: 7
Likes: 0
From: North Carolina
unless your driving threw a lake or water above your hood and your on the stock air box then you will not have a problem. if you don't beileve me then take a gander at how air comes into your engine.
Of the 40,000 other people on here who have WS6's, even those who run custom ram-air setups, about .01% EVER have a water problem.
I like the K&N filters, but lots of people like the stockers. The stock paper filters do a great job, and offer little restriction. My car has a clear lid and a white filter would look like **** under it, or I'd probably run a paper filter too.
I like the K&N filters, but lots of people like the stockers. The stock paper filters do a great job, and offer little restriction. My car has a clear lid and a white filter would look like **** under it, or I'd probably run a paper filter too.
Trending Topics
TECH Fanatic
Joined: Nov 2003
Posts: 1,241
Likes: 0
From: MD
The only reason I run an oiled filter is because I have the intake sealed to the hood with the baffles removed. The outside of the filter does get wet if it's raining hard but with a clear lid I have never seen any moisture get by.
LS1 Tech Stories
The Best V8 Stories One Small Block at Time
6 Common C5 Corvette Failures and What's Involved In Repairing Them
Pouria Savadkouei
Retro Modern Bandit Pontiac Trans AM Comes With Burt Reynolds' Autograph
Verdad Gallardo
Top 10 Greatest Cadillac V Series Performance Models Ever, Ranked
Pouria Savadkouei
Top 10 Most Powerful Chevy Trucks Ever Made!
Hennessey's New Supercharged Silverado ZR2 Has 700 HP
Verdad Gallardo
Coachbuilt N2A Anteros Is an LS2-Powered C6 Corvette In Italian Clothes
Verdad Gallardo
Awesome K5 Blazer Restomod Comes With C7 Corvette Power
Verdad Gallardo
10 Camaros You Should Never Buy
10 LS Engine Myths That Refuse to Die
Verdad Gallardo
Launching!
Joined: Jun 2005
Posts: 293
Likes: 1
From: San Diego, California
You can go about 50,000 miles or more before you need to clean and re-oil.
It just depends where you live and the environment you live in. The filter works better as it gets dirtier.
Some people are a little obsessive and clean it and re-oil every 5,000 to 10,000. The key is to let it dry completely before you install it. You do not want any oil getting into the throttle body or more importantly on the MAF sensor wires. You should just have a paper one on stand by when you clean your K&N. This way you can use your car.
It just depends where you live and the environment you live in. The filter works better as it gets dirtier.
Some people are a little obsessive and clean it and re-oil every 5,000 to 10,000. The key is to let it dry completely before you install it. You do not want any oil getting into the throttle body or more importantly on the MAF sensor wires. You should just have a paper one on stand by when you clean your K&N. This way you can use your car.
