ported my tb
ported my tb hey everyone,just ported my throttebody the other day and just wanted to see what people thought. Im wondering if i should cut the shaft or not. Ive heard that it makes the shaft weak, but ive seen so many people do it. Here are a few pics of it. Im definately going to do the bumpstop mod also.
Looks good! I cut my shaft, and shortened the screws in my ported stocker, but it probably doesn't make a ***** difference. There's plenty of meat on the shaft to hold the blade, even with just half of it.
Make sure you use some blue loctite on those TB screws. If one falls out, your motor is done.
Make sure you use some blue loctite on those TB screws. If one falls out, your motor is done.
I would cut the shaft and grind down the end of the screws holding it on as well (every little bit helps out). Just be careful with the bumpstop b/c if you go to far and the TPS reads over 4.71V at WOT then you'll trip the SES light.
looks good, i would also cut the shaft in half. The front half doesnt even have threads so its not hurting to get rid of. I would also do the bump stop mod with the tb on the car and watching the tps voltage carefully. Got to about 4.65 volts and call it good. Check out my tb's and a couple helpful sites.
https://ls1tech.com/forums/removed-locked-thread-graveyard/651047-ported-tb.html
http://www.installuniversity.com/ins...sity/index.htm
https://ls1tech.com/forums/removed-locked-thread-graveyard/651047-ported-tb.html
http://www.installuniversity.com/ins...sity/index.htm
well just cut off the shaft, and started to knife edge the blade, but it doesnt close right, it sticks when its closed, so i took some sandpaper to the edge, there is a tiny bit of light around the edges, but there was that when it was stock too. heres a few more pics
Yeah for some reason mine always stick after I cut the shaft. I just hold it up to the light to see where the blade is rubbing (usually on the bottom somewhere) and then I'll just sand that part of the blade down a little bit. A little bit of light around the blade is fine. If you port to much of the body and have a lot of light coming around the blade then the car will idle high (I know from first-hand experience)
Trending Topics
LS1 Tech Stories
The Best V8 Stories One Small Block at Time
Gas Monkey Built a 6-Wheel Ferrari Testarossa With a Corvette LT4 Engine
Verdad Gallardo
7 Most Reliable High-Performance Engines GM Has Ever Built
Verdad Gallardo
Amazing '71 Camaro Restomod Is Modern Muscle Car Under the Skin
Verdad Gallardo
6 Common C5 Corvette Failures and What's Involved In Repairing Them
Pouria Savadkouei
Retro Modern Bandit Pontiac Trans AM Comes With Burt Reynolds' Autograph
Verdad Gallardo
Top 10 Greatest Cadillac V Series Performance Models Ever, Ranked
Pouria Savadkouei
Top 10 Most Powerful Chevy Trucks Ever Made!
Hennessey's New Supercharged Silverado ZR2 Has 700 HP
Verdad Gallardo
