**Paging Black Sunshine/ 00SS**
Thread Starter
TECH Addict
Joined: Dec 2001
Posts: 2,337
Likes: 0
From: Auburn, AL
**Paging Black Sunshine/ 00SS** Hey man, quick question about your exhaust if you can help me out. I'm trying to make an exhaust exactly like yours, except with different mufflers. Do you know the measurements of your exhaust? Muffler length, tube length before/after x-pipe, stuff like that. Was there any special clearancing or anything needed to get the dual 3" over the rearend? The panhard rod cause any trouble? Thanks a lot for ANY help at all.
Re: **Paging Black Sunshine/ 00SS** I'm sorry, I dont know the exact length of the pipe. I know the bullets are 16.5" 3" with a 4" case. I have the X right under the driveshaft yoke, from there, I dont know about measurements. If you have Grotts, I can make you up one, minus the Grotts, I could only make you the setup from the X back, & you would have to get a shop to weld up the fronts for you. E-mail me if interested.
The panhard bar was no trouble, however, the stamped piece that attaches above it, and seems to do nothing, that must go if you are looking to go duals over the axle. I guess this summer I should do a complete "How To" on the dual exhaust.
The panhard bar was no trouble, however, the stamped piece that attaches above it, and seems to do nothing, that must go if you are looking to go duals over the axle. I guess this summer I should do a complete "How To" on the dual exhaust.
TECH Resident
Joined: Nov 2001
Posts: 770
Likes: 0
From: the third rock from the sun!
Re: **Paging Black Sunshine/ 00SS** Black Sunshine/ 00SS...On your first exhaust, how many hangers did you have and where. I know you had the ones on each pipe behind the rear seats.
Did you need them anywhere else?
Also, where did you say you got your x-pipe? I was looking at the Dr. Gas stainless 3" x-pipes.
Did you need them anywhere else?
Also, where did you say you got your x-pipe? I was looking at the Dr. Gas stainless 3" x-pipes.
