Generation III External Engine LS1 | LS6 | Bolt-Ons | Intakes | Exhaust | Ignition | Accessories

Sponsored by:

Lid problem?

Reply Subscribe

Search this Thread

Old

Apr 21, 2007 | 07:06 PM

#1

Thread Starter

TECH Enthusiast

iTrader: (1)

Joined: Sep 2005

Posts: 615

Likes: 0

From: ny

Default

Lid problem?

Was it a bitch to fit your MAF sensor in the new lid intake neck. its an slp lid.

Old

Apr 21, 2007 | 10:23 PM

#2

TECH Enthusiast

Joined: Dec 2004

Posts: 588

Likes: 0

From: Zanesfield, OH

Default

Ya it was. I put some heat to the lid inlet and it slid right on.

Old

Apr 21, 2007 | 10:52 PM

#3

TECH Fanatic

Joined: Jan 2006

Posts: 1,050

Likes: 0

From: reading,pa

Default

yea i took a heat gun type thing and it slide in

Old

Apr 22, 2007 | 02:10 AM

#4

Teching In

Joined: Apr 2007

Posts: 49

Likes: 0

From: Spring Hill, Fl

Default

Definately a pain. Some fit easy, some don't. I put just a "scotch" of grease, and then a bit of elbow grease to make it squeeze in.

Old

Apr 22, 2007 | 09:40 PM

#5

TECH Enthusiast

Joined: Dec 2004

Posts: 588

Likes: 0

From: Zanesfield, OH

Default

I was pleased with the super tight fit. My last lid had a gap that I couldn't close with the worm clamp.

Old

Apr 22, 2007 | 10:18 PM

#6

TECH Enthusiast

iTrader: (2)

Joined: May 2006

Posts: 539

Likes: 0

From: Greenwood

Default

Mine slid right on, my buddys on the other hand took some work to fit.

Old

Apr 22, 2007 | 10:25 PM

#7

TECH Apprentice

Joined: May 2006

Posts: 343

Likes: 0

Default

I had a bitch of a time trying to get the MAF seperated from the stock lid, don't remember it being hard to put on the new lid

Reply Subscribe

First
Prev
1 / 1
Next
Last

All times are GMT -5. The time now is 03:46 AM.