Jet hot lt
Thread Starter
TECH Enthusiast
Joined: Jan 2006
Posts: 616
Likes: 0
From: Des Moines, IA
Jet hot lt Hey guys, having a little issue with fitment of jet hot lt, it just doesnt want to go in on the dr side at all, and i dont want to loosen the motor mounts any suggestions? it seems to be getting caught on the steering knuckle also my dip stick is just stuck, it does not want to come out. any ideas?
Staging Lane
Joined: Feb 2006
Posts: 62
Likes: 0
From: Sugarland, TX
pull the steering shaft and all the plugs on dr. side. i dont know what warning there talking about ive put on many sets of headers on camaros and vette's and had one car have a real problem (someone messed up on a bmr k member) when putting it back together makeshure that your tires are straight and the steerting wheel is at 12 o'clock
Thread Starter
TECH Enthusiast
Joined: Jan 2006
Posts: 616
Likes: 0
From: Des Moines, IA
they are approxemnty straight (cant tell, car is at an angle in the garage) and do you have to remove both bolts or can you take one out and pull it loose? Also if its stuck, where and how would you hit it to break it loose? sorry first header install
Trending Topics
LS1 Tech Stories
The Best V8 Stories One Small Block at Time
Gas Monkey Built a 6-Wheel Ferrari Testarossa With a Corvette LT4 Engine
Verdad Gallardo
7 Most Reliable High-Performance Engines GM Has Ever Built
Verdad Gallardo
Amazing '71 Camaro Restomod Is Modern Muscle Car Under the Skin
Verdad Gallardo
6 Common C5 Corvette Failures and What's Involved In Repairing Them
Pouria Savadkouei
Retro Modern Bandit Pontiac Trans AM Comes With Burt Reynolds' Autograph
Verdad Gallardo
Top 10 Greatest Cadillac V Series Performance Models Ever, Ranked
Pouria Savadkouei
Top 10 Most Powerful Chevy Trucks Ever Made!
Hennessey's New Supercharged Silverado ZR2 Has 700 HP
Verdad Gallardo
Coachbuilt N2A Anteros Is an LS2-Powered C6 Corvette In Italian Clothes
Verdad Gallardo
I didnt have to remove anything other than the plugs when I installed my Jet hots on my SS. I did have to grind approx. 1/4" off the casting boss protruding off the side of the block, I believe it was the passenger side. Its only for assembly line purposes and is no longer needed anyway.
Put a block of wood or a phonebook on a jack and put it under the oil pan. Slowly jack it up. You should get a couple of inches of clearance from the engine lifting before the whole car starts to lift off your jackstands. It should give you room to get the drivers side header in. I did that and didn't have to grind the casting boss or remove the steering linkage.
Originally Posted by lswon!!
pull the steering shaft and all the plugs on dr. side. i dont know what warning there talking about ive put on many sets of headers on camaros and vette's and had one car have a real problem (someone messed up on a bmr k member) when putting it back together makeshure that your tires are straight and the steerting wheel is at 12 o'clock
