? About installing LT's and Y-pipe

Reply Subscribe

Thread Tools

Search this Thread

May 7, 2007 | 06:36 PM

SSmokin99

Thread Starter

TECH Fanatic

iTrader: (7)

Joined: Dec 2005

Posts: 1,818

Likes: 1

From: Bay Area, CA

? About installing LT's and Y-pipe

I was wondering if I installed LT's and a Y pipe if it would push my tips further past my bumper..?? I remember reading a thread here a few weeks ago. The reason I'm asking is because I just bought some Corsa tips and I wanted to weld it to my GMMG C/B. Any info would be GREAT!!

May 7, 2007 | 07:25 PM

BigKap94z

TECH Enthusiast

iTrader: (47)

Joined: Apr 2005

Posts: 721

Likes: 1

No it shouldn't. Sometimes you may have to trim the I-pipe on the catback slightly in order to hook it up to the new ORY. Tip placement is done by the hangers, tailpipes(essentially the catback itself.)

May 7, 2007 | 07:33 PM

HIPER-Z

TECH Regular

iTrader: (22)

Joined: Apr 2007

Posts: 492

Likes: 0

From: Layton, UT

I just barely put mine on, and it pushed my tips out about 1/2 inch to a 3/4 inch.

May 7, 2007 | 07:47 PM

Bonertee

Launching!

iTrader: (1)

Joined: Feb 2007

Posts: 255

Likes: 0

From: Concord, N.C.

I installed my Pacesetters and ORY and it didn't move mine at all.

May 7, 2007 | 08:01 PM

connexion2005

12 Second Club

iTrader: (49)

Joined: May 2006

Posts: 966

Likes: 0

From: College Station, Texas

Mine moved quite a bit. A little bit out and a little over. I'll put it this way I had to go get my tips repositioned before I felt good about the looks again. I also did motor mounts to though so I have no doubt that that effected it also since they actually sit a little bit higher than stock.