anybody know what the resistor on the a/c connection is for
anybody know what the resistor on the a/c connection is for when i did my m6 to a4 harness swap my new harness was stuck between the block and w/p. well i had to cut the wires and just had to cut through a resistor or fuse. what is that for? will it mess anything up? if so where can i get a new one.
so do i just put another diode in there. my a/c is acting funny and im wondering if its cuz of that. is the diode connected from the - to the +?
Last edited by 6-Speed Terror; Jul 8, 2007 at 08:38 PM.
I diode only flows one way and since electricity flows from - to + i'd say your right. But I dont know. I just took my compressor out to put a new manifold line on but I dont remember what you are talking about.
