DIY exhaust cutout?
sure if you can make something similar to a throttle body opening, weld/bolt it all up and then attach a small motor to it so it can operate the flange, sounds like a breeeze to me....
I think this would be hard but seeing some of the other creations that have come out of LS1tech, you may never know....
I think this would be hard but seeing some of the other creations that have come out of LS1tech, you may never know....
On The Tree
Joined: Jul 2006
Posts: 124
Likes: 0
From: Weld, ME
Originally Posted by trans99am
ya i was thinking about just using a throttle body. dont know how ghetto it is going to look though
On The Tree
Joined: Jul 2006
Posts: 124
Likes: 0
From: Weld, ME
Originally Posted by Fb0dy0nly
I knew someone would have made one of these. Id like to see some pictures of that, it sounds very interesting.
Trending Topics
LS1 Tech Stories
The Best V8 Stories One Small Block at Time
6 Common C5 Corvette Failures and What's Involved In Repairing Them
Pouria Savadkouei
Retro Modern Bandit Pontiac Trans AM Comes With Burt Reynolds' Autograph
Verdad Gallardo
Top 10 Greatest Cadillac V Series Performance Models Ever, Ranked
Pouria Savadkouei
Top 10 Most Powerful Chevy Trucks Ever Made!
Hennessey's New Supercharged Silverado ZR2 Has 700 HP
Verdad Gallardo
Coachbuilt N2A Anteros Is an LS2-Powered C6 Corvette In Italian Clothes
Verdad Gallardo
Awesome K5 Blazer Restomod Comes With C7 Corvette Power
Verdad Gallardo
10 Camaros You Should Never Buy
10 LS Engine Myths That Refuse to Die
Verdad Gallardo
TECH Resident
Joined: Aug 2005
Posts: 762
Likes: 0
Are you serious? If you dont wanna spend $150 then just crawl under your car and manually uncap it. It would cost you more than $150 in parts if you think you can make one last and seal up. A throttle body is not a good idea when it does not seal all the way around. If it did cars would not idle.
They do make such a thing for $50 the only downfall is they only come in a 2in diameter. If they came bigger like 3in I would have one but I have looked before and all I can find is a 2in.
