EGR Question
EGR Question I was hoping someone could post a pic of an EGR set up on an LS1.. Just to make sure I know what I am talking about..
I was looking at the LS1 FAQ and it says that no 2000-2002 F-Bodys came with the EGR setup.. But I think my 02 LS1 has and EGR system..
Thanks
I was looking at the LS1 FAQ and it says that no 2000-2002 F-Bodys came with the EGR setup.. But I think my 02 LS1 has and EGR system..
Thanks
Trending Topics
LS1 Tech Stories
The Best V8 Stories One Small Block at Time
Amazing '71 Camaro Restomod Is Modern Muscle Car Under the Skin
Verdad Gallardo
6 Common C5 Corvette Failures and What's Involved In Repairing Them
Pouria Savadkouei
Retro Modern Bandit Pontiac Trans AM Comes With Burt Reynolds' Autograph
Verdad Gallardo
Top 10 Greatest Cadillac V Series Performance Models Ever, Ranked
Pouria Savadkouei
Top 10 Most Powerful Chevy Trucks Ever Made!
Hennessey's New Supercharged Silverado ZR2 Has 700 HP
Verdad Gallardo
Coachbuilt N2A Anteros Is an LS2-Powered C6 Corvette In Italian Clothes
Verdad Gallardo
Awesome K5 Blazer Restomod Comes With C7 Corvette Power
Verdad Gallardo
10 Camaros You Should Never Buy
Originally Posted by lastcall190
You explained the AIR system, since you referred to manifold as plural, and that round thing is part of the AIR system (I just ripped the exact thing you described off my car).
-J
-J
Thanks
you might be making this a little but harder than it should be, but thats ok, its scary ripping things out of your car.
when you said round things, im assuming you mean these (in the green boxes)
all the wires going to that go away, gone, throw them out. the only thing you need to cap are the holes in the exhaust manifolds were those cylinder things used to be. after that you shouldnt have any tubes running to your headers/manifolds.
the little hole in the manifold is the thing yo uneed to cap. one on both sides. then you are done.
when you said round things, im assuming you mean these (in the green boxes)
all the wires going to that go away, gone, throw them out. the only thing you need to cap are the holes in the exhaust manifolds were those cylinder things used to be. after that you shouldnt have any tubes running to your headers/manifolds.
the little hole in the manifold is the thing yo uneed to cap. one on both sides. then you are done.
On my motor the hoses that come from the exaust manifolds meet up at a distrobution block.. At the read driver side of the intake..
go to this thread and it is in the middle of the picture..
https://ls1tech.com/forums/lsx-parts-sale/790043-ls1-swap-leftovers.html
go to this thread and it is in the middle of the picture..
https://ls1tech.com/forums/lsx-parts-sale/790043-ls1-swap-leftovers.html
It is tight back there and be careful when tugging and pulling on stuff. I just removed the EGR from my '00, the only thing left is to pull the air pump off, it's annoying to hear it turn on while driving, caught me off guard the first few times. If you are looking for a product to block off the holes and if you have an '00 or later LS1 then you'll need the piece that blocks off the EGR probe port in the manifold. Anyway I purchased a complete set of block off plates/plug from LS1Speed (sponsor on here).