Stainless Edelbrock Victors
#1
TECH Enthusiast
Thread Starter
iTrader: (14)
Join Date: Jun 2006
Location: Mohnton, pa
Posts: 552
Likes: 0
Received 0 Likes
on
0 Posts
Stainless Edelbrock Victors
Anyone using stainless Edelbrock Victor LT's? Im thinking about getting these instead of kooks. How does the stainless ory fit? Anyone have input or should i just stick to kooks? Also how do these fit with a aftermarket Kmember? Anyone had theres fully welded and have any problems?
Last edited by Whitez406; 12-01-2007 at 02:50 PM.
#2
I have the Mild steel version and they fit awesome, as does the ORY. I also had mine fully welded and I would buy them again. If I had the extra coin I would sell mine and buy stainless.
#3
TECH Senior Member
iTrader: (1)
Join Date: Apr 2005
Location: Vancouver,[KITSILANO].B.C. Canada *WestCoast*
Posts: 8,810
Likes: 0
Received 0 Likes
on
0 Posts
I bought the Coated LT's 17 months ago--they still look new--went in fine...ground the tab on dr. side 1/4 inch or so..pass. side went right in....well worth getting EDELBROCKS.
#5
TECH Enthusiast
Thread Starter
iTrader: (14)
Join Date: Jun 2006
Location: Mohnton, pa
Posts: 552
Likes: 0
Received 0 Likes
on
0 Posts
I believe i may end of with a set of these. Does everyone weld the collectors on where they are or is anyone trimming them? Ill take them to work and tig weld the collectors on the headers/ory are about 300-400 cheaper then kooks and there stepped adn stainless.