Owners of Whisper 1 7/8" Headers inside please
Thread Starter
Staging Lane
Joined: Jun 2002
Posts: 58
Likes: 0
From: Plano, TX
Owners of Whisper 1 7/8" Headers inside please I currently have these whisper headers and two cutouts on the Y-pipe right now. I am considering going with the Kooks 1 7/8" stepped headers with X-pipe and dumps before the rear. The motor is a 408 stroker.
My question is do you guys think I would see any gains going to this setup instead of my current.
thanks,
Rusty
My question is do you guys think I would see any gains going to this setup instead of my current.
thanks,
Rusty
Re: Owners of Whisper 1 7/8 Hehe.. hope you weren't looking for many "actual" owners of Whisper headers.. there aren't many.
I have a set on my stock internals car.
The only places I see you could pick up would the area around the steering shaft and the extra length of the collector.
If it was me, I'd focus in other areas first... there might be a little horsepower to gain, but not enough to justify the cost.
I have a set on my stock internals car.
The only places I see you could pick up would the area around the steering shaft and the extra length of the collector.
If it was me, I'd focus in other areas first... there might be a little horsepower to gain, but not enough to justify the cost.
Trending Topics
LS1 Tech Stories
The Best V8 Stories One Small Block at Time
6 Common C5 Corvette Failures and What's Involved In Repairing Them
Pouria Savadkouei
Retro Modern Bandit Pontiac Trans AM Comes With Burt Reynolds' Autograph
Verdad Gallardo
Top 10 Greatest Cadillac V Series Performance Models Ever, Ranked
Pouria Savadkouei
Top 10 Most Powerful Chevy Trucks Ever Made!
Hennessey's New Supercharged Silverado ZR2 Has 700 HP
Verdad Gallardo
Coachbuilt N2A Anteros Is an LS2-Powered C6 Corvette In Italian Clothes
Verdad Gallardo
Awesome K5 Blazer Restomod Comes With C7 Corvette Power
Verdad Gallardo
10 Camaros You Should Never Buy
10 LS Engine Myths That Refuse to Die
Verdad Gallardo
TECH Senior Member
Joined: Nov 2001
Posts: 9,246
Likes: 3
From: Troy, AL
Re: Owners of Whisper 1 7/8 I am also an owner of them. I used them on my 9.82 setup.
I don't think you'll gain much, if any, by going to a 1 7/8-2" stepped header...if that's what you were suggesting. Your Whisper headers flow plenty for that engine, IMO.
I don't think you'll gain much, if any, by going to a 1 7/8-2" stepped header...if that's what you were suggesting. Your Whisper headers flow plenty for that engine, IMO.
Re: Owners of Whisper 1 7/8 Hehe.. yeah, I was waiting for the Colonel to respond. He has more experience with bigger ci/hp motors.
Colonel, your new setup have different headers?
Colonel, your new setup have different headers?
