Possible to install flywheels backwards?
Mine looks like this as of right now. The clutch surface is on the side with the clutch and the backside looks like it hasnt been machined. This is the only way I would think that the flywheel should go on.. so.. the starter is about 3/4" away from where it should be. Its pulled back that far..
Trending Topics
LS1 Tech Stories
The Best V8 Stories One Small Block at Time
6 Common C5 Corvette Failures and What's Involved In Repairing Them
Pouria Savadkouei
Retro Modern Bandit Pontiac Trans AM Comes With Burt Reynolds' Autograph
Verdad Gallardo
Top 10 Greatest Cadillac V Series Performance Models Ever, Ranked
Pouria Savadkouei
Top 10 Most Powerful Chevy Trucks Ever Made!
Hennessey's New Supercharged Silverado ZR2 Has 700 HP
Verdad Gallardo
Coachbuilt N2A Anteros Is an LS2-Powered C6 Corvette In Italian Clothes
Verdad Gallardo
Awesome K5 Blazer Restomod Comes With C7 Corvette Power
Verdad Gallardo
10 Camaros You Should Never Buy
10 LS Engine Myths That Refuse to Die
Verdad Gallardo HAH!
Figured out that problem.
Didnt know that there was a flexplate adapter on the end of the crank! Came stock on the Chevy truck that the engine came out of. Had no clue it was on there until I accidentally put a bolt in the wrong hole and it pushed the adapter off a small amount.
Hopefully this could help someone a whole lot later on.
Figured out that problem.
Didnt know that there was a flexplate adapter on the end of the crank! Came stock on the Chevy truck that the engine came out of. Had no clue it was on there until I accidentally put a bolt in the wrong hole and it pushed the adapter off a small amount.
Hopefully this could help someone a whole lot later on.
I just couldnt figured out any other reason at all.. that the flywheel that is the same for an LS1 LS2 5.3 4.8 and 6.0 was not lining up with my starter... Just was considering all options at the time, because I was about to go nuts.
