What is this part...
Thread Starter
Teching In
Joined: Mar 2006
Posts: 22
Likes: 0
From: Scotrun, PA
Intake is fine. Car has been sitting since August or Sept. And last summer I hardley drove it as I was away on vacation for 6+ weeks.
Trending Topics
I had the same thing happen. You can nRig it or pull the whole pcv system out and put breather filters on the oil cap and back of drivers side valve cover and plug the hole in the intake front and back. From the PCV valve to the front of the intake it's one solid piece that is grommeted into the intake. It's a hard plastic line inside the 5/8 ruber tube all the way around, Advance/AutoZone will not have it. GM dealer priced it at $65, and it's a whole thing. So if your going to replace it you need to pull the intake manifold, which if your doing you mine as well just take it out. GL man.
PS LS1howto.com has a good picture of the PCV system with the 3 lines highlighted. I'd check that out to get a better idea of where the lines run to and fro.
PS LS1howto.com has a good picture of the PCV system with the 3 lines highlighted. I'd check that out to get a better idea of where the lines run to and fro.
LS1 Tech Stories
The Best V8 Stories One Small Block at Time
6 Gifts Neither Your Dad Nor Grad Will Shove Into the 'Trinket Drawer'
Brett Foote
Topdon ONE vs. Artidiag 800 BT2: Which is the Diagnostic Tablet For You?
Pouria Savadkouei
Gas Monkey Built a 6-Wheel Ferrari Testarossa With a Corvette LT4 Engine
Verdad Gallardo
7 Most Reliable High-Performance Engines GM Has Ever Built
Verdad Gallardo
Amazing '71 Camaro Restomod Is Modern Muscle Car Under the Skin
Verdad Gallardo
6 Common C5 Corvette Failures and What's Involved In Repairing Them
Pouria Savadkouei
Retro Modern Bandit Pontiac Trans AM Comes With Burt Reynolds' Autograph
Verdad Gallardo
Top 10 Greatest Cadillac V Series Performance Models Ever, Ranked
Pouria Savadkouei