Need some intake advice
Check out this page, these are some of the configurations he's come up with for people. When you call him tell him Blanco sent you 
http://www.nastyperformance.com/products.html
http://www.nastyperformance.com/products.html
Check out this page, these are some of the configurations he's come up with for people. When you call him tell him Blanco sent you
http://www.nastyperformance.com/products.html
http://www.nastyperformance.com/products.html
Trending Topics
LS1 Tech Stories
The Best V8 Stories One Small Block at Time
6 Gifts Neither Your Dad Nor Grad Will Shove Into the 'Trinket Drawer'
Brett Foote
Topdon ONE vs. Artidiag 800 BT2: Which is the Diagnostic Tablet For You?
Pouria Savadkouei
Gas Monkey Built a 6-Wheel Ferrari Testarossa With a Corvette LT4 Engine
Verdad Gallardo
7 Most Reliable High-Performance Engines GM Has Ever Built
Verdad Gallardo
Amazing '71 Camaro Restomod Is Modern Muscle Car Under the Skin
Verdad Gallardo
6 Common C5 Corvette Failures and What's Involved In Repairing Them
Pouria Savadkouei
Retro Modern Bandit Pontiac Trans AM Comes With Burt Reynolds' Autograph
Verdad Gallardo
Top 10 Greatest Cadillac V Series Performance Models Ever, Ranked
Pouria Savadkouei
Top 10 Most Powerful Chevy Trucks Ever Made!
Heh. Yeah they're pretty unmistakable. I couldn't get ahold of the guys from Nasty Performance today, never got a phone call back from them. Somebody bug them and tell them to check their voicemail
Here's the progress so far
As you can see, it was about 2" too big. Measured how far I could shove it onto the intake manifold, and drew a line on the elbow and cut it down. Fits like a glove
Picked up the MAF from Advanced Auto and the couplers from the local hardware store. This so far has cost $200.
As you can see, it was about 2" too big. Measured how far I could shove it onto the intake manifold, and drew a line on the elbow and cut it down. Fits like a glove
Picked up the MAF from Advanced Auto and the couplers from the local hardware store. This so far has cost $200.