HOGGER

Does anyone have any pictures of their Dynomouth system done the RIGHT way. I have a diagram but I was really hoping to find some pictures. I did a search, none of the links work anymore.

I plan on using the 18 inch muffler. Since it's straight through I figure I will only loose a little volume.

Also what does everyone use after the Y? 2.5 inch?

Thanks.

HOGGER

Also, the exhaust guys I've talked to so far seem to think that the muffler will be too big next to the driveshaft, and possibly rub.

DarkLordFtT

I was going to add the bullet muffler to kill the rasp on my ORYP. When the car is on the lift the rea is hanging, thus the drive shaft is slanted downwards. When the car is on the ground the drive shaft will be up a little higher, and it should clear.

andy98Z

iTrader: (4)

The bullet is still a 4in OD. I put one resonator where the stock dynomax pipe was and another resonator (2 1/2) on the left tailpipe going across the rear of the car.

HOGGER

TTT I'd stiil like some pics

ELS1

here is a rough sketch of the dynomouth setup(this is the RIGHT way)...i had the original pic but lost it...so i attempted to re-create it in paint...hope this helps

Matt98ls1

iTrader: (2)

Here is the original sketch.

pimpmaro

I wish CrazyBosnian would see this and post a picture of his exhaust for an example of workmanship