View Poll Results: Keep the bullets or remove to original set up?
Keep the bullets
2
66.67%
Take them Off
1
33.33%
Voters: 3. You may not vote on this poll
Exhaust Poll, Keep Magnaflow bullets or without?
Thread Starter
Teching In
Joined: Feb 2007
Posts: 32
Likes: 0
Exhaust Poll, Keep Magnaflow bullets or without? Like it says, Notes- Mac mids, magnaflow cats, Flowmaster Y, LM1 , Magnaflow bullets, CME. The most complicated exhaust ever! AKA "Frankenhaust"
It's ok, but not as aggressive as it was without them. I was just trying to keep the levels down to keep from getting unwanted attention!
here they are
Pic
VID's
http://youtube.com/watch?v=RxGLpiY6tFU IDLE REV Without Bullets
http://youtube.com/watch?v=dFG9B0MS2V4 IDLE REV With Bullets
http://youtube.com/watch?v=c1rcQxUWHyo 1-3rd without Bullets
http://youtube.com/watch?v=3fvromMJLlI 1-3rd with Bullets
It's ok, but not as aggressive as it was without them. I was just trying to keep the levels down to keep from getting unwanted attention!
here they are
Pic
VID's
http://youtube.com/watch?v=RxGLpiY6tFU IDLE REV Without Bullets
http://youtube.com/watch?v=dFG9B0MS2V4 IDLE REV With Bullets
http://youtube.com/watch?v=c1rcQxUWHyo 1-3rd without Bullets
http://youtube.com/watch?v=3fvromMJLlI 1-3rd with Bullets
Last edited by driving; Jul 28, 2008 at 08:42 PM. Reason: Added notes
TECH Regular
Joined: May 2008
Posts: 458
Likes: 0
From: Marissa, Il
I think it sounds good in both sets of video. And the Tips have got to be my favorite!
Thread Starter
Teching In
Joined: Feb 2007
Posts: 32
Likes: 0
Yes cats flow Y, LM1 and magnaflow bullets. The video doesnt do just the LM1 justice. Bascally im looking for the same sound before i added the magnaflow muffs just a bit quieter on the the top end. I thought the magnaflows would take the edge off it, but they cut the sound levels in half. So trying to decide to leave em, take em off, or take em off and change the LM1 for a LM2 or Dynomouth set up.
TECH Regular
Joined: May 2008
Posts: 458
Likes: 0
From: Marissa, Il
I say even though it is a bit of work I would Have the lm1 resonator taken out and maybe have it set up with v-band clamps so you can exchange as your tastes change. after that you could have a few different setups made
that you could change as you wish without constatly cuting your exhaust up.
Maybe even have a n electric cutout put in place of the lm resonator so you could have total control.
that you could change as you wish without constatly cuting your exhaust up.
Maybe even have a n electric cutout put in place of the lm resonator so you could have total control.
Trending Topics
LS1 Tech Stories
The Best V8 Stories One Small Block at Time
6 Common C5 Corvette Failures and What's Involved In Repairing Them
Pouria Savadkouei
Retro Modern Bandit Pontiac Trans AM Comes With Burt Reynolds' Autograph
Verdad Gallardo
Top 10 Greatest Cadillac V Series Performance Models Ever, Ranked
Pouria Savadkouei
Top 10 Most Powerful Chevy Trucks Ever Made!
Hennessey's New Supercharged Silverado ZR2 Has 700 HP
Verdad Gallardo
Coachbuilt N2A Anteros Is an LS2-Powered C6 Corvette In Italian Clothes
Verdad Gallardo
Awesome K5 Blazer Restomod Comes With C7 Corvette Power
Verdad Gallardo
10 Camaros You Should Never Buy
10 LS Engine Myths That Refuse to Die
Verdad Gallardo Thread Starter
Teching In
Joined: Feb 2007
Posts: 32
Likes: 0
Heavy maybe im just looking for the right combination.I did think about the V band thing to swap out muffs but would have to have a V-band welded on every muffler i try and that would kill the resale value.
i just put those same bullets on with an h-pipe. they sound awesome. not as loud as i thought they would be, but it has a very nice refined sound. and gets loud at wot. i say keep them. i love the way they sound.
Thread Starter
Teching In
Joined: Feb 2007
Posts: 32
Likes: 0
Cut out is too raspy, in my opinion. Looks like LM2 my be my next bet. Bullets make the car sound stock. Not bad but definitely not like a camaro should sound. Its like a truck, like a F-150 ford to be exact i started my car in the parking lot yesterday and then a guy started his Ford F-150 and swear it was the same. Gotta change it but not sure what too just yet.
