BBK headers sound clip

Reply Subscribe

Thread Tools

Search this Thread

Aug 10, 2008 | 06:37 PM

flintwrench69

Thread Starter

TECH Addict

iTrader: (11)

Joined: May 2008

Posts: 2,017

Likes: 4

From: Mt Morris, Michigan

BBK headers sound clip

Here is a sound clip of my newly installed BBK headers. Its connected to the stock exhaust pipe, w/ a Borla muffler. Not sure on the exact type of Borla, it was on the car when I bought it.
http://s195.photobucket.com/albums/z...t=P8090001.flv

Aug 10, 2008 | 07:03 PM

Badguy7

TECH Addict

iTrader: (6)

Joined: May 2007

Posts: 2,242

Likes: 0

From: Odessa, TX

That sounds pretty sweet, anxious to see how mine will sound with the LoudMouth 2 Muffler.

Aug 10, 2008 | 07:11 PM

Soul TKR

TECH Junkie

iTrader: (4)

Joined: Jun 2004

Posts: 3,543

Likes: 2

From: San Diego, CA

sounds good flint

i gotta get sound clips of my BBK setup...

Aug 10, 2008 | 07:28 PM

LSXDoc

Teching In

iTrader: (8)

Joined: May 2008

Posts: 49

Likes: 0

From: Oklahoma City

I gonna have pretty much the same setup (BBK LTs with Borla Adjustable) just waiting on the time to do put them on. Sounds freakin awesome!! Question...how was the fitmit of the headers????

Aug 10, 2008 | 08:09 PM

Soul TKR

TECH Junkie

iTrader: (4)

Joined: Jun 2004

Posts: 3,543

Likes: 2

From: San Diego, CA

Quote:

Originally Posted by LSXDoc

I gonna have pretty much the same setup (BBK LTs with Borla Adjustable) just waiting on the time to do put them on. Sounds freakin awesome!! Question...how was the fitmit of the headers????

mine fit great

no rubbing, banging, etc...

Aug 10, 2008 | 09:19 PM

flintwrench69

Thread Starter

TECH Addict

iTrader: (11)

Joined: May 2008

Posts: 2,017

Likes: 4

From: Mt Morris, Michigan

BBK header fitment

Quote:

Originally Posted by LSXDoc

I gonna have pretty much the same setup (BBK LTs with Borla Adjustable) just waiting on the time to do put them on. Sounds freakin awesome!! Question...how was the fitmit of the headers????

The install on the headers were very easy. They fell right in. Their instructions say to remove the steering shaft & oil dipstick tube. You have to remove the dipstick tube, not the steering shaft. The ball flanges make bolting up the Y to the headers a breeze too. I posted my install & problem I had with the Y not being a direct fit to the catback here:https://ls1tech.com/forums/generation-iii-external-engine/965449-installed-my-bbk-lts-today-just-one-problem.html
After I had to install poly mounts, I noticed the pass. side collector is kinda close to the heat shield, but I dont get any noise from it. Very happy with the headers though.