Help with intake install
Help with intake install I didn't but the coolant lines to make the switch from ls1 to ls6 intake. I'm taking the ribs off the bottom of intake but the orange sponge thing on bottom is not allowing me to take some of them off. Do i take it off them?
How do you know if you broke the Oil Pressure sending Unit? At the very back there should be a black tube sticking out of the engine with an electrical circuit adapter on it. You should be able to tell if it's cracked if it's there and if it broke off it's probably sitting in the flat valley where the coolant lines run. If you haven't pulled the LS1 intake yet just be very careful that the hose to the Brake Booster does not get caught on it.
Trending Topics
LS1 Tech Stories
The Best V8 Stories One Small Block at Time
6 Gifts Neither Your Dad Nor Grad Will Shove Into the 'Trinket Drawer'
Brett Foote
Topdon ONE vs. Artidiag 800 BT2: Which is the Diagnostic Tablet For You?
Pouria Savadkouei
Gas Monkey Built a 6-Wheel Ferrari Testarossa With a Corvette LT4 Engine
Verdad Gallardo
7 Most Reliable High-Performance Engines GM Has Ever Built
Verdad Gallardo
Amazing '71 Camaro Restomod Is Modern Muscle Car Under the Skin
Verdad Gallardo
6 Common C5 Corvette Failures and What's Involved In Repairing Them
Pouria Savadkouei
Retro Modern Bandit Pontiac Trans AM Comes With Burt Reynolds' Autograph
Verdad Gallardo
Top 10 Greatest Cadillac V Series Performance Models Ever, Ranked
Pouria Savadkouei
Top 10 Most Powerful Chevy Trucks Ever Made!
Here is the picture of the oil sending unit, you cant see it unless the intake is off. Try a search, there is a lot of info on pulling the intake off. If you follow the brake booster hose with your hand to the back of the intake you can feel where it comes very close to the oil sender.
