Stroker Build Progress Pics
11-26-2008, 02:15 AM
#1
TECH Apprentice
Thread Starter
Join Date: Aug 2004
Location: Buffalo, N.Y.
Posts: 321
Likes: 0
Received 0 Likes
on
0 Posts
Stroker Build Progress Pics So far, so good......
What fun it was grinding the Total Seal piston rings for the Diamond Pro-Race cans....my thumbs were tender for a week.
I plastigaged the crank rod journals, and installed main bearings & caps. ARP studs used for main bearing caps.
The Callies 6.125" H-Beams also use ARP fasteners. All rod bolts measured between .005 and .0055 bolt stretch, which equals stupid amounts of torque.
After I got the bare block back from the machine shop, I installed Clevite coated cam bearings. It took about 5 hours, but hey, it was my 1st time, and I didn't want to scratch any of the bearings. I didn't. The OTC cam bearing installation/removal tool made the job a piece of cake.
Next up, degreeing in the cam.
What fun it was grinding the Total Seal piston rings for the Diamond Pro-Race cans....my thumbs were tender for a week.
I plastigaged the crank rod journals, and installed main bearings & caps. ARP studs used for main bearing caps.
The Callies 6.125" H-Beams also use ARP fasteners. All rod bolts measured between .005 and .0055 bolt stretch, which equals stupid amounts of torque.
After I got the bare block back from the machine shop, I installed Clevite coated cam bearings. It took about 5 hours, but hey, it was my 1st time, and I didn't want to scratch any of the bearings. I didn't. The OTC cam bearing installation/removal tool made the job a piece of cake.
Next up, degreeing in the cam.
