Newb question about my built motor
#1
On The Tree
Thread Starter
iTrader: (13)
Join Date: Dec 2008
Location: NJ
Posts: 175
Likes: 0
Received 0 Likes
on
0 Posts
Newb question about my built motor
I am building a lq9 bored 30 over for my ls1 swap into a lt1 1993 trans am. I have forged manley rods, new tefon coated manley pistons and arp bolts all the way around. cometic head gasket and arp head studs. I am keeping the stock crank. I am using a ls6 intake and tb.
My car has a dbb gt42r turbo. Will this motor handle the turbo maxed out? What else would i need to make sure the motor can handle the boost and tq?
I have all suspension up grades, k member,control arms, sub fram connectors and qa1 coilovers.
I have strange 12 bolt rear 373 gears,chromemoly driveshaft, built trans and so on.
My car has a dbb gt42r turbo. Will this motor handle the turbo maxed out? What else would i need to make sure the motor can handle the boost and tq?
I have all suspension up grades, k member,control arms, sub fram connectors and qa1 coilovers.
I have strange 12 bolt rear 373 gears,chromemoly driveshaft, built trans and so on.