LS1TECH - Camaro and Firebird Forum Discussion
LS1-LS2-LS3-LS6-LS7 PERFORMANCE
Generation III Internal Engine
PTVC with Trickflow 215's?

Generation III Internal Engine 1997-2006 LS1 | LS6

Sponsored by:

PTVC with Trickflow 215's?

Reply Subscribe

Search this Thread

Old

Oct 20, 2009 | 04:15 PM

#1

Thread Starter

Staging Lane

iTrader: (3)

Joined: Jan 2007

Posts: 57

Likes: 0

From: Kenosha

Default

PTVC with Trickflow 215's?

OK I know I have to measure and I will, but I thought I'd ask any way.
I will be running a Torquer v.2 with 62cc Trickflow 215's and a stock gasket.
The Torquer v.2 had no issues with my 243's will I have any with the Trickflows? I have measured and it looks good, but I'm using a push rod checker as my push rods haven't arrived yet.
thanks

Old

Oct 21, 2009 | 06:53 AM

#2

TECH Junkie

iTrader: (5)

Joined: Feb 2007

Posts: 3,183

Likes: 3

From: Key West, Florida

Default

what does pushrod length have to do with how close the pistons are to the valves??

how much are the heads milled to get 62cc?

Old

Oct 21, 2009 | 07:32 AM

#3

Thread Starter

Staging Lane

iTrader: (3)

Joined: Jan 2007

Posts: 57

Likes: 0

From: Kenosha

Default

Quote:

Originally Posted by teke184

what does pushrod length have to do with how close the pistons are to the valves??

how much are the heads milled to get 62cc?

I can't get to zero lash with my old pushrods their too short. I'm not sure how much they were milled to get to 62, I thought it would say on the invoice, but it just says 62cc.

Old

Oct 21, 2009 | 07:56 AM

#4

TECH Senior Member

iTrader: (42)

Joined: Jul 2003

Posts: 7,067

Likes: 9

From: HOT'LANA, GAWJA

Default

Why don't you call trick flow and ask them...I am sure that they would know.

Old

Oct 21, 2009 | 08:00 AM

#5

Banned

Joined: Aug 2005

Posts: 154

Likes: 0

From: ohio

Default

A .012" mill is all that's needed to drop them from 64-62cc.

Old

Oct 21, 2009 | 08:58 AM

#6

Thread Starter

Staging Lane

iTrader: (3)

Joined: Jan 2007

Posts: 57

Likes: 0

From: Kenosha

Default

Quote:

Originally Posted by Mike@TEA

A .012" mill is all that's needed to drop them from 64-62cc.

Thank you!

Reply Subscribe

215s, flow, trick

First
Prev
1 / 1
Next
Last

All times are GMT -5. The time now is 02:13 AM.