Sorry but I am a bit confused here. I built a ghetto press to push out the inserts on my rod caps and am installing the rings now but I have hit a snag. The instructions are telling me to line up the gap on the oil ring and its retainers with the wrist pin. I was always taught never to do this with any of the rings and never have the gaps of the other rings line up either and be a little off perpendicular with the wrist pin. The rings are federal mogul sealed power btw. Does this seem right to you?

 

install your rings the same as you always have they will be just fine

 

Thanks!!!

 

no problem let me know if you have any other snags