not a dumb comment. think about it. hes not saying to guess and just go with it regardless. hes saying guess because you could end up measuring and were right. if you werent then youll have to wait and reorder right length ones. if you were right with your guess when you measure-no waiting. these guys arent dumb. come on now. they sponser this site for a reason

 

OP did you get your heads milled? if you did you might be ok with the 7.350 rods I have the PRC stg 2.5 ls6 heads and milled them to 62cc .015 and am running the 7.350's I do have some valve train noise i mean only light but i will order a slightly longer pushrod to quiet that down.

 

nope not milled. and with stock thickness gaskets. not to say i may not have it done down the road. but yeah we will see how it shakes out.