help, im freaking out
#1
Staging Lane
Thread Starter
iTrader: (2)
Join Date: Jun 2010
Location: Kiln,MS
Posts: 75
Likes: 0
Received 0 Likes
on
0 Posts
help, im freaking out
i am doing a camswap on my car and just got the cam plate removed. started sliding the dowel rods into my engine and they wont go in more than half an inch. i turned the cam bot ways 10 or 12 times and they still wont go in. i have tried everything to get them to go. the rods are 5/16 and a little longer than my cam. they go in at the right angle just not in the hole far enough to even get the first lifter. are the rods too fat to go in???? anyone who has had this problem before?? please help!!! what should i do???
#2
On The Tree
iTrader: (1)
Join Date: Dec 2004
Location: 3rd Rock
Posts: 122
Likes: 0
Received 0 Likes
on
0 Posts
http://www.youtube.com/watch?v=s4G4m...e_gdata_player
First calm down drink a beer. Now go try again, sounds like you might be hitting the lifter. When you spin the cam, listen to see if it is contacting the lifter.
First calm down drink a beer. Now go try again, sounds like you might be hitting the lifter. When you spin the cam, listen to see if it is contacting the lifter.
#6
Staging Lane
Thread Starter
iTrader: (2)
Join Date: Jun 2010
Location: Kiln,MS
Posts: 75
Likes: 0
Received 0 Likes
on
0 Posts
lol, not old enough for a beer yet lol. will be 19 friday. and i got it. simple mistake. went to walmart and got some 1/4" wooden dowels from the arts and crafts section and worked perfectly. my rods that i made out of round bar were too fat. i overreacted but am happy now. up at school doin some homework for tomorrow. car will be done and getting a tune thursday. thanks yall
Trending Topics
#8
Staging Lane
Thread Starter
iTrader: (2)
Join Date: Jun 2010
Location: Kiln,MS
Posts: 75
Likes: 0
Received 0 Likes
on
0 Posts
nothing came off the dowels, i made sure there weren't any places it could hang up on before i slid them in. i dont know what the deal was with the round bar. it was slightly larger than the 5/16" wooden ones i got from walmart but idk. i ended up using the 1/4" and they worked great.
#9
On The Tree
iTrader: (1)
Join Date: Dec 2004
Location: 3rd Rock
Posts: 122
Likes: 0
Received 0 Likes
on
0 Posts
lol, not old enough for a beer yet lol. will be 19 friday. and i got it. simple mistake. went to walmart and got some 1/4" wooden dowels from the arts and crafts section and worked perfectly. my rods that i made out of round bar were too fat. i overreacted but am happy now. up at school doin some homework for tomorrow. car will be done and getting a tune thursday. thanks yall
#11
Staging Lane
Thread Starter
iTrader: (2)
Join Date: Jun 2010
Location: Kiln,MS
Posts: 75
Likes: 0
Received 0 Likes
on
0 Posts
FINISHED!!! got my car back from getting tuned today and i absolutely LOVE IT!!! i still have to get the tune done again cause i have a light on but it runs great. i am very happy with the car even though i havent raced or done any solo hits yet due to a brand new clutch. i cant wait to though. wont be long and i will be dyno'ing the car on nov 27th so i will post up some numbers afterwards.