Incorrect Pushrod Length
If the pushrod is incorrect legnth, the rocker will not be center on the valve tip. take the rocker off, mark the tip of the valve with a sharpie, then install the rocker, rotate the engine a few times, unbolt the rocker and inspect the wipe pattern.
Thread Starter
Joined: Mar 2006
Posts: 21,019
Likes: 893
From: The Beach...
Thanks..i'm just trying to check everything before I get the Engine completely back together.
I guess there is probably a specified pre-load aswell..and if it's too long then it would probably be noticeable.
I guess there is probably a specified pre-load aswell..and if it's too long then it would probably be noticeable.
http://www.gmhightechperformance.com.../photo_06.html
this writeup might help ya for aftermarket rockers.
this writeup might help ya for aftermarket rockers.
Last edited by kinglt-1; Apr 8, 2011 at 11:41 AM.
I think preload, at least on the newer LS7 Lifters, is like 0.060" to 0.100" so there is a little wiggle room in there. I set my preload at 0.080"
With proper length and preload it should be reasonably quiet.
Pushrod length is easy to measure and pushrods are easy to replace so you might as well measure and make sure you've got the correct length.
And yes, the rocker arms require 22ft lbs
With proper length and preload it should be reasonably quiet.
Pushrod length is easy to measure and pushrods are easy to replace so you might as well measure and make sure you've got the correct length.
And yes, the rocker arms require 22ft lbs
