I know this is not the correct forum but since it is related, her goes. I am currently in the process of installing Heads/cam in my car. Everything is off and all I need is to re-install everything back on the car. I noticed that I snapped the wires off one of the sensors that go in the back of the intake manifold. It is a three wire connector. The colors are black, green and grey. Does anyone know which order they go in?

Thanks
Ever

 

Here is a pic. It is the sensor on the rear of the intake manifold. The one with the rubber hose underneath it. I pulled the wires off the connector that goes in the sensor.

 

Maybe someone is doing a heads and cam install and can tell me what order they go in.

Thanks
Ever

 

Well I figured out the answer thanks to a fellow member(Ed B98SS) on another site. It is the MAP sensor and the answer is:

A) BLK (ground)
B) LT GRN (sensor signal)
C) GRY (5.0V reference)

Looking at the sensor, locking tab on top from left to right would be A, B and C

 

Let the H/C installation continue! Finally!

Peace
Ever