wires getting burned on headers
Thread Starter
Teching In
iTrader: (1)
Joined: Jul 2009
Posts: 19
Likes: 0
From: Clarksville,TN & Fayetteville,NC
wires getting burned on headers I just put new hooker headers on my 99 z28 ls1 and the wires are getting burned from the wires sitting on the headers..tried wraping them in heat shield tape but still burned them any suggestions on keeping them off the haders or high temp wires anything really..
I have MSD wires and they bend actually, so get you a set of those then snap them onto the plug and bend them over off the header. I have had my MSD wires on and bent away from the headers for about 20k miles and have no problems what so ever.
Last edited by 00pooterSS; Jul 13, 2011 at 08:43 AM.
Trending Topics
11 Second Club
iTrader: (27)
Joined: May 2005
Posts: 6,799
Likes: 5
From: Your girl's back door giving her the long stroke while you're at work
LS1 Tech Stories
The Best V8 Stories One Small Block at Time
Topdon ONE vs. Artidiag 800 BT2: Which is the Diagnostic Tablet For You?
Pouria Savadkouei
Gas Monkey Built a 6-Wheel Ferrari Testarossa With a Corvette LT4 Engine
Verdad Gallardo
7 Most Reliable High-Performance Engines GM Has Ever Built
Verdad Gallardo
Amazing '71 Camaro Restomod Is Modern Muscle Car Under the Skin
Verdad Gallardo
6 Common C5 Corvette Failures and What's Involved In Repairing Them
Pouria Savadkouei
Retro Modern Bandit Pontiac Trans AM Comes With Burt Reynolds' Autograph
Verdad Gallardo
Top 10 Greatest Cadillac V Series Performance Models Ever, Ranked
Pouria Savadkouei
Top 10 Most Powerful Chevy Trucks Ever Made!
Hennessey's New Supercharged Silverado ZR2 Has 700 HP
Verdad Gallardo
I turn mine where the plug wire connects to the coil. It pulls the plug wire away from the header just enough to keep them from burning.
