Pushrod length questions
12-19-2011, 08:10 AM
#1
Launching!
Thread Starter
iTrader: (1)
Join Date: Feb 2009
Location: Farmington, Mn
Posts: 221
Likes: 0
Received 0 Likes
on
0 Posts
Pushrod length questions I've got a 5.3 and I put in a new cam. I measured the new cam and the old cam and came up with .031" difference in the base circle radius (.062 total).
The stock pushrods are 7.400-7.402 and the Comps are 7.418-7.420 which leaves them short around .013" on average.
Do you figure that's pretty good or should I measure anything more?
FYI, motor has 65k, stock, have used LS6 springs, new double roller, cam is @ .550 lift / 272
Thanks
The stock pushrods are 7.400-7.402 and the Comps are 7.418-7.420 which leaves them short around .013" on average.
Do you figure that's pretty good or should I measure anything more?
FYI, motor has 65k, stock, have used LS6 springs, new double roller, cam is @ .550 lift / 272
Thanks
12-19-2011, 10:13 PM
#2
TECH Resident
I think you will find some good info in post #3... https://ls1tech.com/forums/generatio...s-too-big.html
