what cam would you recommend for me?
If you would like to make an informed decision on a camshaft based on the mechanical principles, you may want to read the thread below "Camshaft Discussion II". First rate information.
Glen
Glen
Sorry guys, my Pacesetter review is based on y-pipe installation. But for what it's worth, Jethots or Hookers are the same design and slide right in. No grinding the block (are you serious?!)
Originally Posted by Derek98z
Sorry guys, my Pacesetter review is based on y-pipe installation. But for what it's worth, Jethots or Hookers are the same design and slide right in. No grinding the block (are you serious?!)
All of the above mentioned headers would be way better then the MAC's .... I have actually only heard or one or two people who grinded their blocks, and I doubt it was even necessary, I think they just did it for piece of mind.
12 Second Club
Joined: Apr 2003
Posts: 351
Likes: 0
From: Austin, Texas
want loud? if this isnt loud i dont know what is, check it out http://www.alexviveiros.com/Chris/uvs040212-001.MPG g5x2 cam, pacesetter lt's, true duals w/ x-pipe, sweet thunder mufflers, i found this vid in the multimedia section. if you want more performance and loudness go with lt's, if you wanna save gas a little go with the macs. mac mids are only loud when you hammer it. 
Last edited by dallas; Mar 17, 2004 at 04:48 PM.
Thread Starter
TECH Fanatic
Joined: May 2003
Posts: 1,445
Likes: 0
From: Southeast Texas
Originally Posted by dallas
if this isnt loud i dont know what is, check it out http://www.alexviveiros.com/Chris/uvs040212-001.MPG g5x2 cam, pacesetter lt's, true duals w/ x-pipe, sweet thunder mufflers, i found this vid in the multimedia section. if you want more performance and loudness go with lt's, if you wanna save gas a little go with the macs. mac mids are only loud when you hammer it.
