LS1TECH - Camaro and Firebird Forum Discussion
LS1-LS2-LS3-LS6-LS7 PERFORMANCE
Generation III Internal Engine
What is this?

Generation III Internal Engine 1997-2006 LS1 | LS6

Sponsored by:

What is this?

Reply Subscribe

Search this Thread

Old

Oct 31, 2012 | 12:22 PM

#1

Thread Starter

TECH Enthusiast

iTrader: (6)

Joined: Aug 2010

Posts: 584

Likes: 3

Default

What is this?

Got the lq4 block back from machine shop and this part was in with the bolts for the main caps. They said it goes in the back of the block, but i don't really see where it would go.

Anyone have pictures of where to install it and how?

Attached Thumbnails

What is this?-20121030_094508.jpg

Old

Oct 31, 2012 | 12:34 PM

#2

TECH Fanatic

iTrader: (13)

Joined: Dec 2003

Posts: 1,455

Likes: 2

From: Okc,OK

Default

Engine oil galley plug. You have to pull the rear cover off & there will be a hole on the lower driverside of the block.. Leave it out & you wont have any oil pressure. You can push it in by hand, ribbed non o-ring end first, the rear cover holds it into place.

Last edited by MM98; Oct 31, 2012 at 12:44 PM.

Old

Oct 31, 2012 | 01:04 PM

#3

Thread Starter

TECH Enthusiast

iTrader: (6)

Joined: Aug 2010

Posts: 584

Likes: 3

Default

Ok, thanks. Does it go in sort of over where the crank position sensor is, but obviously going into the back side under the cover?

Old

Oct 31, 2012 | 01:24 PM

#4

TECH Fanatic

iTrader: (13)

Joined: Dec 2003

Posts: 1,455

Likes: 2

From: Okc,OK

Default

Opposite side, crank sensor is on the pass side of the block.. The galley plug hole will be right above the lower rear cover bolt hole.

Reply Subscribe

Thread Tools

Search this Thread

Show Printable Version

Show Printable Version

Email this Page

Email this Page

First
Prev
1 / 1
Next
Last

All times are GMT -5. The time now is 07:17 AM.