Lq4 no oil pressure
Thread Starter
12 Second Club
iTrader: (12)
Joined: Feb 2008
Posts: 407
Likes: 0
From: westminster MD
Lq4 no oil pressure i have a 2004 gmc Sierra 2500 6.0. I was driving and out of no where it started ticking. I thought it was rod knock but when I got it back to my shop I pulled a valve cover and I was not getting oil to the top of the motor. The ticking was not a knock but was a colasped lifter. So, no oil pressure to the top of the motor I figured the oil pump went out. Tube was fine o ring fine and no crushed oil filter. Help
Thread Starter
12 Second Club
iTrader: (12)
Joined: Feb 2008
Posts: 407
Likes: 0
From: westminster MD
Just one bad lifter. As of now at least. Hoping since I maybe went a half mile easy going 25 mph it would have popped back up but I have to get oil pressure first
Thread Starter
12 Second Club
iTrader: (12)
Joined: Feb 2008
Posts: 407
Likes: 0
From: westminster MD
Yeah it looked fine to me the funny part is that before I tore it apart I was getting a very small I mean very small amount of oil to the top of the motor. Now iam getting nothin
Trending Topics
LS1 Tech Stories
The Best V8 Stories One Small Block at Time
Gas Monkey Built a 6-Wheel Ferrari Testarossa With a Corvette LT4 Engine
Verdad Gallardo
7 Most Reliable High-Performance Engines GM Has Ever Built
Verdad Gallardo
Amazing '71 Camaro Restomod Is Modern Muscle Car Under the Skin
Verdad Gallardo
6 Common C5 Corvette Failures and What's Involved In Repairing Them
Pouria Savadkouei
Retro Modern Bandit Pontiac Trans AM Comes With Burt Reynolds' Autograph
Verdad Gallardo
Top 10 Greatest Cadillac V Series Performance Models Ever, Ranked
Pouria Savadkouei
Top 10 Most Powerful Chevy Trucks Ever Made!
Hennessey's New Supercharged Silverado ZR2 Has 700 HP
Verdad Gallardo
Coachbuilt N2A Anteros Is an LS2-Powered C6 Corvette In Italian Clothes
Verdad Gallardo Thread Starter
12 Second Club
iTrader: (12)
Joined: Feb 2008
Posts: 407
Likes: 0
From: westminster MD
Gauge inside the truck says zero. I'm gonna pull the motor out put it on the stand and go ever it. I'm gonna check the tube barbell o ring and all the bearings.
