Hey guys I found a motor from a friend of mine but he is away an I'm going to pick it up but I can't make the plate there and I'm in Canada and don't have time to wait for one and also pay duty for over night shipping I wanna build one that at worst I just drill holes at the site when I pick up the motor !

Anyone can measure there intake flange for me or know where there is a template ??

Josh

 

Chain?

 

Use an old LS1 valley cover and weld 2 aluminum "D's", hoops, or equivalent.

 

[QUOTE=dr_whigham;17075580]Use an old LS1 valley cover and weld 2 aluminum "D's",

That's what I did, traced valley plate and welded tabs onto my steel plate.

 

2 bolts & a chain. It's genius!!!

 

Anyone have some measurements

 

Can anyone trace a valley pan out for me or give me measurements I have to drive 3 hours to pick up this motor and don't have a way to build stuff on site I wanna unbolt the intake and valley and bolt plate on and pull engine and drop on trsiler

 

Go to Autozone, get a new gasket and use it to mark the holes, since you can't use chain and bolts.

 

Ill try the gasket tomorrow idea thanks. It's -40 out and I rather not mess around with chains in the cold. Plus I got to drive 3 hours for it.

 

Well called 4 places around here $40 bucks and nothing till Friday. Welcome to Canada.

If anyone can give me the measurements ill shot them $5 bucks for min of there time.

 

What is it you are wanting measurements of again?