04 GTO LS1 4 wire harness help
Thread Starter
Registered User
Joined: Oct 2014
Posts: 1
Likes: 0
04 GTO LS1 4 wire harness help Hello all, I will start off by saying I have a motor set out of a 04 GTO with a complete harness, ecu, and t56 trans. What I'm trying to do is convert the harness to a 4 wire setup. I'm putting the engine in my S13. I know they make harnesses that will work but I eliminated the chassis harness and want to run everything off a switch panel for simplicity. I have researched and haven't found too much on how to convert the harness. I have found info on the lt1 swap site for my specific harness but not too sure on how to exactly make it 4 wires and where to put fuse blocks etc. I haven't been able to find a specific write up step by step on how to do this. Does anyone have insight on how to convert my harness. I'm looking for a guide that can walk me through the process. I have the factory pcm and plan on using it, not buying the f body ls1 pcm. I'm located in so Cal if that helps anyone. I've found companies such as speartech that makes harnesses. Obviously I would prefer to do it on my own. Any thoughts would help and be appreciated.
Welcome to LS1tech!
This is the internal engine section. You know, rods, cranks, oil pumps.....
We have a super GTO section, you'll find great help over there. There's also a conversions section that may be of interest to you.
This is the internal engine section. You know, rods, cranks, oil pumps.....
We have a super GTO section, you'll find great help over there. There's also a conversions section that may be of interest to you.
