looking at putting together a 370 for nitrous, looking for some input on the combo ive put together so far...

LQ4 block bored to 4.030
stock crank
scat I beams or eagle h beams arp bolts
wiseco K398X3 -3.2cc pistons
cometic .040 gasket
243 heads ported an maybe milled
should be around 10.9-11.1 compression
super vic intake
Induction solutions sledgehammer plate
4150 throttle body
Holley dominator efi or MS3pro

going in a 89 s10 with a glide on a small tire.

havnt specd a cam yet for it either.

ill be putting a 250+hp shot to it. will that combo be a good setup? kinda a budget 370 build so dont want nothing super crazy

 

I'd cut the heads down to like 58cc and run a thicker gasket for a wider quench area .051-.065 give you some cushion on your nitrous tune up, and you'll definitely want to open those heads up a bit.

 

I have almost identical bottom end as you are planning. I have 317 heads milled .020" and am running a carb. That motor should run good in an s10

 

i can get the cometic gaskets in .045 0.51 or .060

 

I have almost identical bottom end as you are planning.

 

im running a stock bore 6.0 motor with heads cut 30 thou. 700 heads with 40 thick head gasket.. but im carb I still run 93 fuel both on motor and gas 150 shot,,, video in sig and times