First Rebuild Help
Thread Starter
Teching In
Joined: Jul 2019
Posts: 3
Likes: 0
First Rebuild Help Hello this is my first rebuild of a motor(i have a LM7 5.3 i just got back from the shop ) i got it cleaned honed,heads(862) resurfaced, the cam and crank polished and little thinks like pistons,rods lifters Etc... so i was told for bearing(main and rod) that i needed standard bearing.Also i had new cam bearing put in..
The question is .. What are some good main and rod bearing for a starter project.. down the line i want to turbo 400-500 hp but right now i just want to future proof the motor a little.
I did see a set of King bearing for 53 on amazon don't know if there good or bad. price range it between 50$ - 125$
not-a-sponsor.com
The question is .. What are some good main and rod bearing for a starter project.. down the line i want to turbo 400-500 hp but right now i just want to future proof the motor a little.
I did see a set of King bearing for 53 on amazon don't know if there good or bad. price range it between 50$ - 125$
not-a-sponsor.com
Last edited by KCS; Jul 4, 2019 at 09:16 AM.
