SPANKY LS1

iTrader: (24)

Who here runs a sheetmetal intake? How much low end did you lose, how much does it help, etc? Also, what size motor is it on, any 346s? I keep seeing and hearing how "it'll kill your low end torque", "it'll peak too high", etc. Everyone says we are ultimately limited by our intake flow(LS6), but if our heads flow a large enough amount of air (such as some S2 or S3 heads), wouldn't too much intake be better than not enough? How much of a trade-off would there be? Would it hurt more than it helps, would you lose more than you would gain?