LS1TECH - Camaro and Firebird Forum Discussion

Generation III Internal Engine 1997-2006 LS1 | LS6
Sponsored by:
Sponsored by:

Allign hone necessary when replacing mains with new GM bolts?

Thread Tools
 
Search this Thread
 
Old 04-13-2005, 09:20 AM
  #1  
TECH Apprentice
Thread Starter
 
Y2K2LS1's Avatar
 
Join Date: May 2002
Location: one step ahead of you
Posts: 338
Likes: 0
Received 0 Likes on 0 Posts

Default Allign hone necessary when replacing mains with new GM bolts?
NOT ARP STUDS, just new GM bolts. I'm pulling the crank out for new cam bearings and will be replacing the main bolts with new GM units.

Thanks
Y2K2LS1 is offline  
Reply Like
Old 04-13-2005, 10:02 AM
  #2  
TECH Addict
iTrader: (59)
 
Bo White's Avatar
 
Join Date: Oct 2004
Location: Vance, Alabama
Posts: 2,357
Likes: 0
Received 0 Likes on 0 Posts

Default
Its always best to check but shouldnt be a problem when swapping same type fasteners.
Bo White is offline  
Reply Like
Back to Subforum
Generation III Internal Engine
View Next Unread
Does thismake sense? Stock 6.0 Motor, w/ cam needs shorter then 7.4 pushrod?




Advanced Search

All times are GMT -5. The time now is 04:15 PM.