F13 with PRC's

Reply Subscribe

Thread Tools

Search this Thread

Jun 17, 2005 | 06:53 PM

#21

f-bodman

TECH Enthusiast

Joined: Jan 2004

Posts: 539

Likes: 1

From: Grand Rapids, MI

Thanks gomer, just measured mine and they came out to exactly 1.61. Damn, after flycutting I was kinda hoping they were milled, since the only reason I got them unmilled is so I wouldn't have to.

Jun 17, 2005 | 07:06 PM

#22

gomer

11 Second Club

iTrader: (13)

Joined: Jun 2002

Posts: 3,063

Likes: 0

From: The Confederacy

Quote:

Originally Posted by f-bodman

Thanks gomer, just measured mine and they came out to exactly 1.61. Damn, after flycutting I was kinda hoping they were milled, since the only reason I got them unmilled is so I wouldn't have to.

Damn, that's strange. I'm doing a set next week that have been milled .020 with a F13 114+2, I'm going to measure the P/V on it to see if I'm going to have to flycut. I'll post up what I find out.

Jun 17, 2005 | 08:35 PM

#23

01tam6

Thread Starter

On The Tree

iTrader: (1)

Joined: Jul 2004

Posts: 170

Likes: 0

From: Opp, Alabama

Quote:

Originally Posted by f-bodman

Thanks gomer, just measured mine and they came out to exactly 1.61. Damn, after flycutting I was kinda hoping they were milled, since the only reason I got them unmilled is so I wouldn't have to.

Well may run into some trouble after all. I am going to drive to Futral for the install. Do they check the clearance on all installs, by request, or only if they think its necessary. Don't get me wrong I KNOW that they know what they are doing but I am just curious.

Jun 17, 2005 | 08:59 PM

#24

gomer

11 Second Club

iTrader: (13)

Joined: Jun 2002

Posts: 3,063

Likes: 0

From: The Confederacy

Quote:

Originally Posted by 01tam6

Futral is a top notch shop and I'm sure they will check and double check everything on the car and make sure it is set up right before you get it back, regardless of what they have to do to it.

Jun 19, 2005 | 11:30 AM

#25

f-bodman

TECH Enthusiast

Joined: Jan 2004

Posts: 539

Likes: 1

From: Grand Rapids, MI

Quote:

Originally Posted by gomer

Damn, that's strange. I'm doing a set next week that have been milled .020 with a F13 114+2, I'm going to measure the P/V on it to see if I'm going to have to flycut. I'll post up what I find out.

Cool, if you could check the valve drop at TDC I would greatly appreciate it, I just want to know if my heads really are different from what other people are using and that would be a good indicator. If those heads are the same as mine, after they've been milled .020 the valve drop should be ~.105.

Reply Subscribe