what sensor is this? pic

Reply Subscribe

Thread Tools

Search this Thread

Sep 10, 2005 | 01:25 PM

ProjecT 9

Thread Starter

TECH Fanatic

iTrader: (6)

Joined: Mar 2004

Posts: 1,235

Likes: 0

From: Houston

what sensor is this? *pic*

i have had a sensor unplugged for god knows how long now, i just found it unplugged when i was checking my header bolts today...im assuming it has been unplugged since the H/C install (april)...i think its the knock sensor but i want to make sure...and if this has been unplugged since my previous dyno, could this make my car run alil better or not? assuming my car might have been knocking and i just never knew it?

this isnt my motor btw, its a motor off ls1howto's site...i was just tring to find a pic of the sensor i was talking about..

thank in advance..

Jon

Sep 10, 2005 | 01:59 PM

Byter

Launching!

iTrader: (1)

Joined: Mar 2004

Posts: 200

Likes: 0

From: Pennsville, NJ

That is the harness for the two knock sensors going into the top of the valley cover.

Sep 10, 2005 | 02:02 PM

ProjecT 9

Thread Starter

TECH Fanatic

iTrader: (6)

Joined: Mar 2004

Posts: 1,235

Likes: 0

From: Houston

Quote:

Originally Posted by Byter

That is the harness for the two knock sensors going into the top of the valley cover.

ya, thanks for the responce...after i posted i did some more research and found out it was...im just glad i seen it there..thanks again

Jon

Sep 10, 2005 | 04:32 PM

ArcticZ28

TECH Senior Member

iTrader: (14)

Joined: Jun 2004

Posts: 5,125

Likes: 4

From: Alexandria, VA

Haha, nice. I bet you can get a few more ponies now without all that possible timing pulled at god knows where... not to mention it'll be easier to tune