Will I have clearance issues with the following??
Thread Starter
On The Tree
Joined: May 2004
Posts: 151
Likes: 0
Will I have clearance issues with the following?? I am putting the following on soon and am wondering if anyone has done the same or has experience to advise.
New PP 5.3 heads (2.02"/1.57")
GM Hotcam (already have it)
Crane 1.8 RR's (already have them)
Standard GM gasket.
Stock short block.
Thanks,
Tom.
New PP 5.3 heads (2.02"/1.57")
GM Hotcam (already have it)
Crane 1.8 RR's (already have them)
Standard GM gasket.
Stock short block.
Thanks,
Tom.
TECH Senior Member
Joined: Mar 2004
Posts: 14,620
Likes: 17
From: BFE
218/228 525/525 112
Are your heads milled?/
If not then don't even worry, you'l have enough clearance to run a bus through there.
I would run Cometic .045 to better your quench and reducing detonation (+ a couple more HPs)
Are your heads milled?/
If not then don't even worry, you'l have enough clearance to run a bus through there.
I would run Cometic .045 to better your quench and reducing detonation (+ a couple more HPs)
