heads for a 346-348
heads for a 346-348 I'm looking at some of the heads people are delivering for a small bore motor...
and it seems the TEA 5.3 stage 3 are the best heads avialable for $2,000
has anyone else found any different?
and it seems the TEA 5.3 stage 3 are the best heads avialable for $2,000
has anyone else found any different?
question about the 5.3 and the afr 205
without milling the 5.3 aproximately what CR would i be at? I'd like to see about 11.25:1
would milling the 205 to get the 11.25 hurt the flow numbers enough to make them flow less than the TEA 1.5 stage 3?
without milling the 5.3 aproximately what CR would i be at? I'd like to see about 11.25:1
would milling the 205 to get the 11.25 hurt the flow numbers enough to make them flow less than the TEA 1.5 stage 3?
