oil pressure / clearance question
oil pressure / clearance question I got my lme 347 in and running. On cold startups I have over 40 psi oil pressure at idle. But when my car is warm and the idle lowers to 750rpm, oil pressure drops to 20-25 psi. I think it's mostly because of my low idle rpm that it drops so low because when i get moving at over 1000rpm my oil pressure is right back up at 40 psi. My build sheet says .0025" main clearance and .0024" rod. Is everything normal here? Should I think about running thicker oil (german castrol 0w30 synthetic now), raise my idle rpm, or just leave everything the way it is?
your main clearance is a little large. should be .018 to .020. Maybe heavier oil as predator suggested. Too many builders forget the aluminum block expands and they clearance the mains as though it is an iron block.
Trending Topics
Originally Posted by P Mack
Nothing's changed since I posted. But at my next oil change I'm gonna try 10w40 or something to see if i makes a difference.
LS1 Tech Stories
The Best V8 Stories One Small Block at Time
Gas Monkey Built a 6-Wheel Ferrari Testarossa With a Corvette LT4 Engine
Verdad Gallardo
7 Most Reliable High-Performance Engines GM Has Ever Built
Verdad Gallardo
Amazing '71 Camaro Restomod Is Modern Muscle Car Under the Skin
Verdad Gallardo
6 Common C5 Corvette Failures and What's Involved In Repairing Them
Pouria Savadkouei
Retro Modern Bandit Pontiac Trans AM Comes With Burt Reynolds' Autograph
Verdad Gallardo
Top 10 Greatest Cadillac V Series Performance Models Ever, Ranked
Pouria Savadkouei
Top 10 Most Powerful Chevy Trucks Ever Made!
Hennessey's New Supercharged Silverado ZR2 Has 700 HP
Verdad Gallardo
Coachbuilt N2A Anteros Is an LS2-Powered C6 Corvette In Italian Clothes
Verdad Gallardo Whoops, forgot about this thread. Going from 0w30 to 5w50 made no noticeable difference in oil pressure. After talking to a few people, I'm not concerned about this at all. Any time the engine the engine is under load the rpms are high enough to bring the oil pressure to >40.
TECH Senior Member
Joined: Mar 2004
Posts: 14,620
Likes: 17
From: BFE
I have a LME block as well, with ported pump. It has the same symptoms 28psi at idle but goes up to 50 at WOT. The crank bearing tolerances have to do with that effect.
Ring seal is super, no oil burning (1qt every 2000 miles). Also ported oil pumps with aftermarket blocks tend to do that as well.
Ring seal is super, no oil burning (1qt every 2000 miles). Also ported oil pumps with aftermarket blocks tend to do that as well.