How much power would I leave on the table if...
#1
TECH Enthusiast
Thread Starter
Join Date: Dec 2003
Location: Warner Robins, GA
Posts: 535
Likes: 0
Received 0 Likes
on
0 Posts
How much power would I leave on the table if...
I used my AFR 205's with 60cc chambers and 1-3/4" headers on a 402.
I'm thinking seriously of buying a forged short block from one of the vendors here but I don't really want the exspense of a new set of heads and new headers. Would using my old ones still net me decent power?
Appreciate any input.
I'm thinking seriously of buying a forged short block from one of the vendors here but I don't really want the exspense of a new set of heads and new headers. Would using my old ones still net me decent power?
Appreciate any input.
#3
TECH Enthusiast
Thread Starter
Join Date: Dec 2003
Location: Warner Robins, GA
Posts: 535
Likes: 0
Received 0 Likes
on
0 Posts
Standard valve sizes 2.02 intake and 1.60 exhaust.
If I had to I could sell them and buy the 225's. I'm just looking at saving some bucks.
If I had to I could sell them and buy the 225's. I'm just looking at saving some bucks.